Can A Trolling Motor Shaft Be Shortened?

If your motor is too long, you can shorten its shaft. The shaft should be shortened at a service center. You can void your warranty if you shorten the shaft yourself.

Does shaft length matter on trolling motor?

It’s important to choose the right shaft length for the trolly motor so that it doesn’t cause a noise. The top of the motor’s foot should be covered by at least 12 inches of water.

Why are trolling motor shafts so long?

You need to factor in wave action if you want to establish the mount-to-waterline distance. A longer shaft is needed to keep the propeller submerged in the water.

Is a longer shaft better on a trolling motor?

The longer shaft is great for making sure your motor stays in the water and maintains stability while you steer in rough conditions.

Can you adjust the height of a trolling motor?

If the shaft is too long, you can always adjust it with the depth collar adjustment found on nearly all trolly motor. You are out of luck if you pick a shaft that is too short.


How long will a 55 lb thrust trolling motor run?

The battery’s Amp-Hour rating is a factor in the runtime. The 55lb thrust motor has a 50ah battery that can run for an hour.

What happens if shaft is too long?

A long driver shaft can make it hard for the player to find the middle consistently. Ball speed and distance can be reduced by off-centre hits.

How many amp hours do I need for a 30lb thrust trolling motor?

The Minn Kota Endura C2 30 Freshwater Transom Mounted Trolling Motor (30″ Shaft) can do 30 lbs of thrust, which is more than the Minn Kota Endura C2 can do in a day. The thrust of 40 to 45 lbs is roughly 29 Amps/HR instead of 42 Amps/HR.

See also  Best Trolling Motor For Small Jon Boat

What are the benefits of a shorter driver shaft?

If you shorten the shaft it will make the club shorter but it will also make the shaft stiffer and adjust the swing weight. The less flex your club has, the more you have to shorten it. It can move a regular flex to a stiff or a stiff to an extra stiff.

How do you tell if you need a short shaft or long shaft?

To measure the center of the transom, you need to measure from the top to the bottom. You’ll need a short shaft outboard if it’s more than an inch in an inch. You’ll want to go with a long shaft motor if it’s more than 17 inches high.

Can you cut the shaft on an electric motor?

There is a problem with cutting a shaft because the magnets inside the motor will collect iron and cause it to fail in flight. Remove the shaft and clean it. Both methods work well.

Can you cut an iron shaft down?

The same shaft can be trimmed to fit all iron clubs. You will need to trim the butt end in order to get the club length you want.

Can I cut my own driver shaft?

If you want to shorten a steel shaft, use a hacksaw. The grip on the shaft needs to be reinstalled. The swingweight feel of the club can be restored by adding weight to the clubhead.